D2R Hits Blinds Target Guide: Eternity, Curses and Equip Order
Barbarian Runewords Item Mechanics

D2R Hits Blinds Target Guide: Eternity, Curses and Equip Order

Looking to progress faster? Grab Diablo II Resurrected Runes from Elyxir.

Buy D2R Runes
Looking to progress faster? Grab Diablo II Resurrected Runes from Elyxir. Buy D2R Runes

D2R Hits Blinds Target Guide: Eternity, Curses and Equip Order

Understand which enemies blindness affects, how it competes with damage curses, and when re-equipping Eternity can help.

Item MechanicsRunewordsBarbarian
D2R Hits Blinds Target Guide: Eternity, Curses and Equip Order - A Barbarian strikes a ghost as blindness competes with curses.
A Barbarian strikes a ghost as blindness competes with curses.

Overview

Hits Blinds Target can make a melee weapon safer to use, but it also raises an important gearing question: will blindness replace Amplify Damage or Decrepify? Learn how this interaction works in Diablo II: Resurrected, which enemies are unaffected, and how equipment order can reduce conflicts when using Eternity alongside a curse-triggering item.

What Hits Blinds Target Actually Does

Hits Blinds Target applies a single-target blinding effect through successful attacks. Unlike a manually cast area curse, it does not automatically cover the surrounding pack. Its main purpose is defensive: affected monsters have restricted awareness and become less effective at engaging targets from a distance.

Blindness is not the same as a stun, and it does not make an enemy harmless in every situation. A blinded monster can still be dangerous when a target is close enough. Think of it as interference with monster behavior rather than a guarantee that attacks stop.

The important complication is that this effect interacts with the curse system. On a susceptible monster, blindness can replace an existing curse, including one your build uses to increase physical damage.

Why replacing a curse matters

Amplify Damage lowers physical resistance. Decrepify also lowers physical resistance while slowing enemies and reducing their damage. Losing either effect can make a noticeable difference to a physical attacker, especially against resistant targets.

This creates a trade-off: blindness offers control, while a damage curse may offer faster kills and, in Decrepify's case, additional protection. The problem is not that blindness is inherently bad. It is that the wrong effect can remain on the monster after an attack.

Which Monsters Can Be Blinded?

Hits Blinds Target is an AI-altering effect, so its usefulness depends on whether the target can be affected by that kind of control. It is not a universal debuff that works on every enemy.

  • Ordinary monsters: Many can be blinded and can therefore experience conflicts between blindness and another curse.
  • Champions and unique monsters: These are generally immune to this kind of AI manipulation.
  • Super uniques and act bosses: Blindness does not control these enemies.
  • Special monster types: Some ordinary-looking enemies also resist AI-altering effects, including Oblivion Knights and the Minions of Destruction.

This distinction makes the downside narrower than it first appears. Many important targets cannot be blinded in the first place, so the feared replacement of a useful curse by blindness is not an issue against them.

However, do not assume that every monster accompanying a boss shares the same immunity. Ordinary minions and individual monster families need to be considered separately.

Physical-immune ghosts deserve extra attention

Susceptible physical-immune monsters are a more awkward case. Ghost-type enemies in Hell can make a physical build rely on Amplify Damage or Decrepify to break immunity where possible. If blindness replaces that curse, physical damage can become ineffective again.

Neither damage curse breaks every physical immunity. Whether it succeeds depends on the monster's resistance, and immunity-breaking penalties apply. If your usual curse does not solve the encounter, use an appropriate alternative damage source or skip the enemy rather than repeatedly attacking without a plan.

How Equip Order Affects Competing Curses

When multiple relevant effects resolve from the same attack event, their order can determine which curse remains. For competing item-based curses sharing a trigger event, the practical ordering rule is:

First equipped, last cast; last equipped, first cast.

For an Eternity setup, the desired sequence is blindness first, followed by Amplify Damage or Decrepify. When the damage curse successfully triggers afterward, it replaces blindness rather than being replaced by it.

This is why removing Eternity and equipping it again can help. Doing so makes it the most recently equipped item, placing its effect earlier in the relevant curse sequence.

Ordering is not the same as guaranteed uptime

Equipment order only resolves the order of effects that actually occur. A chance-to-cast curse must still pass its trigger roll. Lawbringer, for example, does not trigger Decrepify on every attack.

Likewise, Hits Blinds Target should not be treated as an unconditional application against every monster on every swing. Target eligibility and the blindness mechanics still matter.

If blindness applies on an attack that does not trigger your preferred curse, the monster can remain blinded. Correct ordering reduces a conflict when both effects occur together; it does not guarantee permanent Amplify Damage or Decrepify.

The Practical Eternity Re-Equip Routine

For a dual-wield Barbarian combining Eternity with a curse-triggering weapon, a short preparation routine is the simplest way to manage the interaction.

  • Enter the game and equip your intended combat gear.
  • Perform any weapon-swap buff routine first.
  • Return to your combat weapon set.
  • Remove Eternity and place it back into its intended weapon slot.
  • If you swap weapons again, repeat the re-equip step after returning to combat gear.

The timing matters. Fixing the order before switching to a buff set can undo the benefit, because returning to the combat set causes the weapons to be equipped again.

Keep this adjustment separate from other gearing decisions. Re-equipping a weapon does not improve a curse's trigger chance, change its duration, or make an immune monster susceptible to blindness.

Why weapon swapping can reset the arrangement

When the game equips a weapon set, it processes the character's right-arm slot before the left-arm slot. Because the relevant curse order is reversed, the weapon equipped first resolves its competing curse later.

This becomes confusing because the inventory is presented from the viewer's perspective. The weapon slot above the gloves corresponds to the character's right arm; the slot above the boots corresponds to the left arm.

If Eternity occupies the slot that is automatically processed first, manually re-equipping it after a swap changes that sequence. This is the situation where the routine is especially useful.

Barbarian Skills and Non-Weapon Curse Sources

Frenzy and Double Swing

Dual-weapon attacks require attention to both weapon placement and the effects carried by each weapon. Placing the weapons so the automatic equip sequence already produces the desired curse order can reduce maintenance.

However, do not rearrange weapons solely for this interaction without considering the rest of the build. Attack behavior and the role of each weapon still matter. A reliable re-equip habit may be preferable to compromising the intended setup.

Berserk

Berserk uses one weapon for its attack rather than alternating between both weapons like Frenzy. Keep the intended attacking weapon in the appropriate primary position instead of moving it merely to simplify curse ordering.

Also remember that Berserk converts its attack's physical damage to magic damage. Amplify Damage and Decrepify are not direct multipliers for that converted magic damage, although physical mercenary damage and other physical attacks may still benefit from them.

D2R Hits Blinds Target Guide: Eternity, Curses and Equip Order - A Barbarian re-equips Eternity to adjust competing curse effects.
A Barbarian re-equips Eternity to adjust competing curse effects.

Atma's Scarab

Atma's Scarab supplies Amplify Damage from an amulet rather than a second weapon. Under the normal equipment sequence, the amulet is equipped before the weapons, which favors its curse resolving after weapon-based blindness when both relevant effects trigger.

This generally makes the interaction easier to manage than a competing off-hand weapon curse. It still does not remove the chance-to-cast limitation: an unsuccessful Amplify Damage roll cannot overwrite anything.

How Much Should This Affect Your Gear Budget?

Hits Blinds Target alone is not a strong reason to discard Eternity. Judge the weapon by its complete role in the build, the enemies you fight, and how dependent your damage is on a particular curse.

Before committing valuable D2R runes to a setup, check three things: whether your main targets can be blinded, where your damage curse comes from, and whether your normal buff routine changes the weapon order.

When comparing Diablo 2 Resurrected items, prioritize a functional combination over an idealized interaction. A build that needs a low-probability curse to solve every ordinary encounter may remain inconsistent even with perfect equipment ordering.

Frequently Asked Questions

Does Hits Blinds Target replace Amplify Damage?

It can replace it on monsters susceptible to blindness. If Amplify Damage subsequently triggers, it can replace blindness in turn.

Will re-equipping Eternity guarantee Decrepify stays active?

No. It can improve the resolution order when competing effects occur together, but Decrepify must still successfully trigger.

Do I need to re-equip Eternity after every weapon swap?

If your dual-wield setup relies on manually changing its equip order, repeat the adjustment after returning to your combat set. Some slot arrangements already produce the desired order automatically.

Can Hits Blinds Target interfere with boss fights?

Act bosses and other enemies immune to this form of AI control cannot be blinded. The curse conflict primarily concerns susceptible ordinary monsters.

What is the safest way to handle physical-immune ghosts?

Use a curse that can actually break their immunity, watch whether it remains active, and retain an alternative damage option or skip enemies your setup cannot kill efficiently.

Alicia Mendez

About Alicia Mendez

A lifelong MMO player, Alicia writes about World of Warcraft, Final Fantasy XIV, Throne and Liberty, and New World from the perspective of someone who loves both the grind and the community. From endgame progression to casual exploration, she covers what keeps players invested in living online worlds.

View all posts by Alicia Mendez